ASCASO Ceme 120V 3 WAY Solenoid i.706

 ODE electro 3 way solenoid valve 120V


Details:

ODE electrovalve for models with a solenoid  - see below. Regular machine descaling usually prevents this from getting blocked, but sometimes tiny debris in the water can block or ristrict it .

To prevent these solenoids from  blocking: Descale every month - this can act to remove scale + minerals and metal particulates that can build up and block the 1mm opening in the valve.

You may need this part if:
- No water is coming from the group - the solenoid valve could be blocked with lime or debris.
- Water is constantly dripping from the group when steaming the milk.
- If machine is not descaled every 3-4 months.

Type:  3 WAYS 4,5W
Electrical : 120V 50/60HZ
Size: 1/8x1/8 (8.4mmx 8.4mm)
Outlet pipe: 6.4mm
 


 Fits the following models: if not sure - let us know when model was made customerservice@bluestarcoffee.eu

• ascaso Arc with new thermoblock 09/2012 +
• ascaso Basic new thermoblock  
• ascaso Dream one - before 06/2022
• ascaso Dream PID - 07/2017+
• ascaso Dream with thermoblock 09/2012 +
• ascaso Dream boiler +10/2009
• ascaso Kap - all models
• ascaso Steel most models inc PID
• Bezzera DE Galatea

Replacing the valve:   - Allow 15-30 min - You will need Teflon tape and spanners to replace this .
- Make sure that the machine is plugged out 1st 
- Remove silicon tube and ss nut
- Slide off the electro valve - (Take note where the wires go if removing the wires)
- Remove both nuts holding the elbow fittings.
- Finally remove the old solenoid valve .
- Remove the elbow fittings from old valve: 💡Fittings are glued with thread locker, so you can use boiling water to melt the glue and make removal easier.
- Insert new elbow fittings with teflon tape  
- Put every thing back and check for leaks

💡When fitting this solenoid valve  - take note of the arrow - it should be pointing away from the boiler. See your old one, if you reverse the valve - it wont work and you will have redo.

Suitable fittings:

• Elbow fitting 1/8"M x 1/8"M Fits on no.2 side
• Elbow fitting 1/8"M x 8mmM Fits on no.1 side - (We dont have this fitting - you will have to recycle the old one.) 

Note: To prevent these solenoids from  blocking: Descale every month - this can act to remove scale + minerals and metal particulates that can build up and block the 1mm opening in the valve.