Ascaso Ceme 3 Way Solenoid 230V 588

Replacing the valve:  

Allow 15-30 min - You will need PTFE Sealing Tape and Spanners to replace this.

- Make sure that the machine is plugged out 1st 
- Remove silicon tube and ss nut
- Slide off the electro valve - (Take note of where the wires go if removing the wires)
- Remove both nuts holding the elbow fittings.
- Finally, remove the old solenoid valve.
- Remove the elbow fittings from the old valve: Fittings are glued with a thread locker, so you can use boiling water to melt the glue and make removal easier.
- Insert new elbow fittings with Teflon tape  
- Put everything back and check for leaks

When fitting this solenoid valve  - take note of the arrow - it should be pointing away from the boiler. See your old one, if you reverse the valve - it won't work and you will have redo it.

Suitable fittings:

• Steel Elbow Fitting 1/8M Fits on no.2 side
• Elbow fitting 1/8"M x 8mmM Fits on no.1 side - (We don't have this fitting - you will have to recycle the old one.) 

Note: To prevent these solenoids from blocking: Descale every month - this can act to remove scale + minerals and metal particulates that can build up and block the 1mm opening in the valve..

Fits models: 

• Ascaso Arc with solenoid (+11/2008) with this boiler left
• Ascaso Basic with solenoid (+04/2015) with this boiler left
• Ascaso Dream with solenoid (+11/2008) with this boiler left
• Ascaso Steel with solenoid +11/2008 with this boiler left
•  
• Also found on Arc Basic Dream and Steel with new thermoblock - see tech drawing above