This is the smaller 61.5mm compact pump found in home or small espresso machines that are plumbed.
For the larger 200L 99mm pump click here. It is a Mid volume 50L brass pump with a balanced by-pass, to adjust the pump pressure. It's factory set at 9 bar so you don't need to adjust it.
Rotary vane pumps can fail, when debris jams the bearings or rust forms in the bearings due to age or inactivity.
Water or steam can splutter from the groups indicating poor flow of water. If, when you dismount the pump, you can't rotate the shaft with your hand easily - then the bearings are damaged/ rusted and the pump must be replaced.
N.S.F. approved
Specifications:
Adjustable: Factory set at 9 bar - adjustable to up to 15.8 bar
Flowrate: 50 liters per hour
Connection: 3/8'' thread
Length: 61.5 mm without the pin
Pump rate: 50 L/H
Material: Brass + steel bearings
Manu Code: CA0054AGAFN2800
Includes:
Flat rod
Brass pump
The clamp for the motor included
Not Included:
3/8x3/8 fittings - can be purchased below, ⚠️ Make sure that the pump is protected by a filter (0.15mm mesh) to prevent the entry of particles and foreign bodies. Click here or see below.
Fits the following brands :
ASTORIA CMA: Plus for you, ADRIA, ARGENTA, BRAVA, CK, CKE, CKX, CKXE, DENISE, DORA, LISA, PRATIC, PRATIC NEW, VANIA
Turn off machine and if plumbed turn off mains supply.
Remove water inlet hose and water outlet hose with a spanner
Use a screwdriver to remove the pump clasp
Remove pump
Remove the 3/8'' fittings , so they can be reused. (The fittings are often glued and so can be difficult to remove - You can purchse new fittings or insert the pump upside down in boiling water for 10 min to soften the glue on the fittings.)
Insert the fittings into the new pump using PTFE tape for the seal - on both sides of the thread - (PTFE tape on the thread x 4 )
Insert the new pump back into the motor - screwing on the pump clasp
Finally screw on the inlet and boiler hoses
Turn back on water inlet supply.
Turn back on the machine and press coffee button to check for leaks - tighten fittings and the hose pipes in there leaks.
Tools
+ + 🔧
Screw driver + PTFE tape + spanner.
There are 1 reviews with an average rating of 5.00
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
.png)
Details:
