Quickmill Vibration Pump pulsor

Fits on any vibration pumps: ( ⚠️Make sure you have room for this modification - see dimensions below.)

• Bezzera: Magica, BZ 35, BZ40 | most models with a vibration pump
• ECM: Puristika - fits well
• Quickmill - all models with vibration pump
• Gaggia Classic: Tight fit due to cup warmer - but fits.
• Nuova Simonelli: Musica, Oscar - fits well -See the review on Reddit - see images of before and after here
• Lelit: Elizabeth PL92T, Kate PL82T,  Victoria -  fits well - See review on this page
• Rancilio: Silvia- fits well - See the review on Reddit
• Magister: Stella Pro -  fits well
• Ukla EX5
• Ulka EP5
• Ceme pump
• Olab Pump 22000 
• Ars pump

 💡Fittings:

• 1/8" See here

1. Screw the plastic fitting into the pump, using PTFE tape to make the seal.
2. The thread on the pulsar is too long for EX5 EP5 - so PFTE tape must be used to make the seal.
3. Screw your original pump fitting into the brass fitting -  use PTFE tape to make the seal.
4.  While this noise-reducing valve fits vibration pumps - there may not be enough clearance inside some machines. 💡Care should be taken to make sure that the new valve does not make contact with the steel case. Padded tape, could be used to absorb vibrations if the valve sits tight against the machine cover.

 💡Extra 1/8" Fittings -  See here