Ascaso CEME 588 230V Solenoid I.259  €49.99

Fits the following models: if not sure - let us know when the model was made customerservice@bluestarcoffee.eu

• ascaso Kap Coffee group
• ascaso Dream one Coffee group
• Dream Zero Coffee group
• ascaso Dream PID Coffee group
• ascaso Steel  PID Uno Coffee group
• ascaso Steel  PID Duo Steam solenoid - See drawing above
• ascaso Dream boiler +10/2009 
• ascaso Arc       with brass boiler 
• ascaso Basic   with thermoblock  or brass boiler 
• ascaso bar       with thermoblock or brass boiler 
• ascaso Dream with thermoblock or brass boiler 
• ascaso Steel   with thermoblock or brass boiler 

Replacing the valve:   - Allow 30 min

1. 10mm spanner
2. 12mm spanner.
3. Teflon tape

How to fit:
- Make sure that the machine is plugged out 1st 
- Remove silicon tube and ss nut
- Slide off the electro valve - (Take note of where the wires go if removing the wires)
- Remove both nuts holding the elbow fittings.
- Finally, remove the old solenoid valve.
- Remove the elbow fittings from the old valve: Fittings are glued with a thread locker, so you can use boiling water to melt the glue and make removal easier (or purchase fittings below)
- Insert new elbow fittings with Teflon tape  
- Put everything back and check for leaks

When fitting this solenoid valve  - take note of the arrow - it should be pointing away from the boiler. See your old one, if you reverse the valve - it won't work and you will have to redo it.

Suitable fittings:

• Elbow fitting 1/8"M x 1/8"M Fits on no.2 side - see below
• Elbow fitting 1/8"M x 8mm M Fits on no.1 side - (We don't have this fitting - you will have to recycle the old one.)  When the old solenoid is removed use a wrench to loosen this one - easy to take off.