Ode 230v 3-way solenoid for Ascaso and Dalla Corte models
If the water is very slow to come from the group without coffee, then the solenoid may be blocked. Typically if the machine was not used for a number of months or if in a hard water area, there could be a build-up in the solenoid valve or in the coffee group where the valve connects to.
Descale 1st and if still slow, you may need to replace the valve.
Technical:
Outlet ø 7 mm
RUBY seal - orifice ø 1.5 mm
Coil: BDA08024DS
Electrical: 14.5VA 24VAC 50/60Hz
Temperature -40°C +180°C
How to replace a solenoid valve:
Make sure you have turned off the water connection before you remove these valves, otherwise, water will spurt out of the group.
Remove the 4 hexagonal nuts with an Allen key - make sure you have the correct Allen key otherwise, you may damage the nut.
Insert the Allen key into the hexagonal nut and tap anti-clockwise with a spanner - this will break the seal caused by a mineral build-up.
When replacing make sure that the hole of the solenoid is correctly aligned with the hole in the coffee group, otherwise, you won't get any water from the group. Also make sure the o rings are present on the base of the body, as they can slip off during transport.
If you have to replace it while the machine is still warm - be careful as hot water will pour from the group - better to do it while it cold.
Refit the coil and check the body for leaks.
💡If screws were hard to take off - then you should replace them with new screws, as next time they may not come off if they are damaged. see solenoid screw hex M4X10.
Fits:
Ascaso Steel, Uno Dou Trio +06/ 2009 Steel Duo 2012 See image of the boiler above left
Ascaso Barista Professional boiler group +04/2012
Ascaso Bar boiler group: See image of the boiler above left
Galway, Ireland
