Sage/Breville Olab solenoid 3 way 240V  €34.99

Fits models:

• Breville Sage solis Barista express BES860,BES860XL
• Breville Sage solis Barista express BES870,BES870XL
• Breville Sage solis Barista Pro BES878
• Breville Sage solis Barista Pro BES880

Will not fit: Models with plastic base - see below.

• Breville Sage solis Barista Pro BES878, BES880
• Breville Sage solis Barista express BES870, BES870XL

Simple to replace

1. Remove  the 3 electrical connectors on the solenoid
2. Remove the silicon tube from the top of the valve.
3. Remove the  solenoid
4. Remove the push fitting from old valve or see below for a metal replacement.

Installation: 

• 1st remove the existing solenoid valve.
• Then remove the 2 x 1/8" fittings and rub with a wire brush to remove the thread locker. Keep aside as you will need to reuse these or see here for fittings
• 💡Take note of your existing valve position - by taking an image of the existing solenoid.
• 💡 Pay particular attention to the no1 position and the no. 2 position on the valve. Make sure position no. 1 is in the same position after you are done. The valve is one-way and must be in the correct position - otherwise, you will have to reverse it. 
• You will need to use PTFE plumbers tape to make this seal - see PTFE Sealing Tape or below. Wrap once around each 1/8" fitting.

When finished if the circuit is not working probably the solenoid valve needs reversing.

💡If you need to replace the plastic fitting that came originally with this fitting.

You can use these fittings - they are steel so will last a lifetime

See below or here

1. Sage/Breville Push fitting 1/8 x 4mm
2. Universal Fitting 1/8F x 1/8F
3. PTFE Sealing Tape

1. You will need to cut off the brass olive that is attached to the existing Ptfe Teflon Pipe
2. Insert your Ptfe Teflon Pipe into the push fitting.