Lelit 57mm Naked Portafilter Wood generic  €39.99

Accessories:

•  Coffee Tamper 57mm  *Precision-Coffee-Tamper-57.4mm 
• **Competition basket: 57mm Competition Filter 7Gr H20 | 57mm Competition Filter 14Gr H23 
• IMS double Lelit Double Basket B642Th
• Competition shower IMS CompetitionCi35WM Shower Screen
• Motta 57mm leveler MottaAdjustable Leveler 57mm
• Funnell 53mm Coffee Dosing Funnel Magnetic 53mm
• Coffee shower puck 53mm Lower Shower Puck Screen Thick
• WDT tool Wood Needle Distributer Wdt Tool

** ⚠️ Only suitable for machines 3 years or older - otherwise it will leak, from the extra pressure of a competition basket.

* The 57.4mm will not fit Ascaso 57.3mm baskets

• Lelit Anna PL41,  PL41TEM ** 💡 Fits lelit models made before 2021, ideally - see note below**
• Lelit Anita PL42       - see note below**
• Lelit Dianna PL60   - see note below**
• Lelit Grace PL81    - see note below**

•  illy Francis Francis: X-series with brass boiler (2nd generation and newer. Won't fit: Trio, Iperespresso or pod-only versions.
• Isomac: Giada, Giada super, Brio, Cappuccina, Diamantina, Maverick, Splendida.💡Measure your portafilter as Isomac have different size portafilters.
• La Pavoni**: Domus Bar |Buondi  |  Club | Duet | Napolitana | Puccino PCL  
• Starbucks: Athena, Barista
• Saeco:Aroma, Poemia, Rio Profi, Via Venezia, Magic, Classico, Via Veneto, Armonia, Espresso Dream, Gran Crema

Will not fit:  

• Lelit  Giulietta | Glenda |​ Silvana | Bianca |Mara |Kate |Victoria | Elizabeth
• Ascaso 57mm: Dream, Basic, Arc, Ellipse - Fins are too wide and too deep
• Isomac: Itala, Millennium, Mondiale, Rutiuale, Tea, Venus, Zaffiro. 
• Francis Francis: Trio, Iperespresso, or pod-only versions

💡**For models less than 2 years - the fins will be a little thick at 6mm.

• If fins are too thick, PF will sit at 5 o'clock instead of 6 o'clock. Older models have a little wear, on the brass group head - so they would fit at 6 or 7 o clock.
• Check your portafilter fins to see if they are 6mm, if they are then this will fit your model.
• A possible solution for new machines made after 2021 - replace the group gasket - it will have more give and allow a better seal.